Схема и документация усилителя Yamaha RXV 540 440 HTR 5640 5650RDS
Формат файла: PDF
RX-V540/RX-V540RDS/HTR-5650/HTR-5650RDS/DSP-AX540 RX-V440/RX-V440RDS/HTR-5640/HTR-5640RDS/DSP-AX440
RX-V540/RX-V540RDS/HTR-5650/HTR-5650RDS/DSP-AX540RX-V440/RX-V440RDS/HTR-5640/HTR-5640RDS/DSP-AX440
161 (6-5/16")
140 (5-1/2")
349.5 (13-3/4")
(13/16")
(3/4")
(13/16")
389 (15-5/16")
435 (17-1/8")
Unit : mm (inch)o?NN???
WARNING: CHEMICAL CONTENT NOTICE!
The solder used in the production of this product contains LEAD. In addition, other electrical/electronic and/or plastic (whereapplicable) components may also contain traces of chemicals found by the California Health and Welfare Agency (andpossibly other entities) to cause cancer and/or birth defects or other reproductive harm.
DO NOT PLACE SOLDER, ELECTRICAL/ELECTRONIC OR PLASTIC COMPONENTS IN YOUR MOUTH FOR ANY REA-SON WHATSOEVER!
Avoid prolonged, unprotected contact between solder and your skin! When soldering, do not inhale solder fumes or exposeeyes to solder/flux vapor!
If you come in contact with solder or components located inside the enclosure of this product, wash your hands beforehandling food.
I TO SERVICE PERSONNEL
1. Critical Components Information
Components having special characteristics are marked sand must be replaced with parts having specifications equalto those originally installed.
2. Leakage Current Measurement (For 120V Models Only)
When service has been completed, it is imperative to verifythat all exposed conductive surfaces are properly insulatedfrom supply circuits.
Meter impedance should be equivalent to 1500 ohm shuntedby 0.15
I IMPEDANCE SELECTOR
IMPEDANCE SELECTOR
WARNING:Do not change the IMPEDANCE SELECTOR switch setting while the power to this unit is on, otherwise this unit may be damaged.
"CAUTION""F701, 702: FOR CONTINUED PROTECTION AGAINST RISK OF FIRE, REPLACE ONLY WITH SAME TYPE 8A, 125V FUSE."
CAUTIONF701, 702: REPLACE WITH SAME TYPE 8A, 125V FUSE.
ATTENTIONF701, 702: UTILISER UN FUSIBLE DE RECHANGE DE MEME TYPE DE 8A, 125V.
Leakage current must not exceed 0.5mA.
Be sure to test for leakage with the AC plug in both polarities.
· DIMENSIONSGO$