Схема видеокамеры Other SONY DCR-TRV410/TRV410E/TRV510/TRV510E

Формат файла: PDF

DCR-TRV410/TRV410E/TRV510/TRV510E
4-2. PRINTED WIRING BOARDS AND SCHEMATIC DIAGRAMS
(For printed wiring boards)·
: Pattern from the side which enables seeing.
(The other layers' patterns are not indicated.)
· Through hole is omitted.· Circled numbers refer to waveforms.· There are few cases that the part printed on diagram
isn't mounted in this model.
· Chip parts.
(For schematic diagrams)· All capacitors are in
F unless otherwise noted. pF :
50V or less are not indicated except for electrolytics andtantalums.
· Chip resistors are 1/10W unless otherwise noted.
· Caution when replacing chip parts.
New parts must be attached after removal of chip.Be careful not to heat the minus side of tantalum capacitor, Be-cause it is damaged by the heat.
· Some chip part will be indicated as follows.
· Constants of resistors, capacitors, ICs and etc with XX indicate
that they are not used.In such cases, the unused circuits may be indicated.
· Parts with
differ according to the model/destination.
Refer to the mount table for each function.
· All variable and adjustable resistors have characteristic curve B,
unless otherwise noted.
· Signal name
: non flammable resistor
: fusible resistor
: panel designation
: IN/OUT direction of (+,­) B LINE.
: adjustment for repair.
· Circled numbers refer to waveforms.
(Measuring conditions voltage and waveform)
· Voltages and waveforms are measured between the measure-
ment points and ground when camera shoots color bar chart ofpattern box. They are reference values and reference wave-forms.
(VOM of DC 10 M
input impedance is used.).
· Voltage values change depending upon input impedance of VOM
1. Connection
2. Adjust the distance so that the output waveform of Fig. a and
the Fig. b can be obtain.
Fig. a (Video output terminal output waveform)
Fig.b (Picture on monitor TV)
Electron beam scanned frame
CRT picture frame
THIS NOTE IS COMMON FOR WIRING BOARDS AND SCHEMATIC DIAGRAMS(In addition to this, the necessary note is printed in each block)
Kinds of capacitor
Temperature characteristics
External dimensions (mm)
Note :The components identified bymark
or dotted line with mark
are critical for safety.
Replace only with part numberspecified.
Note :Les composants identifi?s parune marque
sont critiques
pour la s?curit?.Ne les remplacer que par unepi?ce portant le num?ro sp?cifi?.
When indicating parts by reference number, pleas includethe board name.
CD-212 (CCD IMAGER) PRINTED WIRING BOARD (720H MODEL)
-- Ref. No. CD-212 Board; 10,000 Series --
CD-212 BOARD
Front of the lens
Pattern box
For printed wiring boards· This board is eight-layer print board. However, the pat-
terns of layers two to seven have not been included inthe diagram.
· Chip parts
There are few cases that the part printed on thisdiagram isn't mounted in this model.
IC1401 A-3IC1402 B-2IC1403 B-1
CD-212 (TRV410/TRV510)CD-213 (TRV410E/TRV510E) (CCD IMAGER)
PC-72 (TRV510/TRV510E)HONEY, JPEGD/D CONV, INTERFACEFLASH MEMORY, DIGITAL STILL CONTROLLER
MA-356STEREO MIC AMP, LASER LINK
PJ-97(AV IN/OUT)
SE-88(STEADY SHOT)
DD-117(DC/DC CONVERTER)
VF-126(COLOR EVF)