Схема телевизора Other 11AK19E-3

Формат файла: PDF

DO NOT CHANGE ANY MODULE UNLESS THE SET IS SWITCH OFF
The mains supply side of the switch mode power supply transformer is live.
Use an isolating transformer.
The receivers fulfill completely the safety requirements.
Safety precautions:
Servicing of this TV should only be carried out by a qualified person.
- Components marked with the warning symbol on the circuit diagram are critical for safety and must only be replaced with an identical
- Power resistor and fusable resistors must be mounted in an identical manner to the original component.
- When servicing this TV, check that the EHT does not exceed 26kV.
TV Set switched off:
Make short-circuit between HV-CRT clip and CRT ground layer.
Short C804 (150mF) before changing IC802 or other components in primary side of SMPS.
Measurements:
Voltage readings and oscilloscope traces are measured under following conditions.
Antenna signal 60dB from colourbar generator. (100% white, 75% colour saturation)
Brightness, contrast, colour set for a normal picture.
Mains supply, 220VAC, 50Hz.

PERI-TV SOCKET

SCART 1 (SC050)
SCART 2 (SC051)
Audio right output
0.5Vrms / 1K
1 Audio right output
0.5Vrms / 1K
Audio right input
0.5Vrms / 10K
2 Audio right input
0.5Vrms / 10K
Audio left output
0.5Vrms / 1K
3 Audio left output
0.5Vrms / 1K
4 Ground AF
Ground Blue
5 Ground Blue
Audio left input
0.5Vrms / 10K
6 Audio left input
0.5Vrms / 10K
0.7Vpp / 75ohm
7 Blue input
0.7Vpp / 75ohm
AV switching input
0-12VDC /10K
8 AV switching input
0-12VDC /10K
Ground Green
9 Ground Green
11 Green input
0.7Vpp / 75ohm
13 Ground Red
13 Ground Red
14 Ground Blanking
14 Ground Blanking
15 Red input
0.7Vpp / 75ohm
16 Blanking input
0-0.4VDC, 1-3VDC / 75ohm
17 Ground CVS output
17 Ground CVS output
18 Ground CVS input
18 Ground CVS input
19 CVS output
1Vpp / 75ohm
19 CVS output
1Vpp / 75ohm
20 CVS input
1Vpp / 75ohm
20 CVS input
1Vpp / 75ohm
1. INTRODUCTION
11AK19 is a 90? and 110? chassis capable of driving 20-21,24,25,28-29,32,33 tubes at appropriate currents.
The chassis is capable of working in both PAL and SECAM. The sound system is capable of giving 6watts
RMS output into a load of 8ohms.
One 8 page simple TELETEXT, TOPTEXT and FASTEXT is provided.
The chassis is equipped with 21-pin scart connectors which can accept via scart the SVHS format from VCRs so equipped.
2. SMALL SIGNAL PART WITH TDA884X
The TDA8840/8842/8844 combine all small signal functions required for a colour TV receiver, except tuning.
2.1. Vision IF amplifier
The IF-amplifier contains 3 AC-coupled control stages with a total gain control range which is higher than 66dB.
The sensitivity of the circuit is comparable with that of modern IF-IC s. The video signal is demodulated by means of a PLL
carrier regenerator. This circuit contains a frequency detector and a phase detector. The AFC output is obtained by using the
VCO control voltage of the PLL and can be read via the I?C-bus. For fast search tuning systems the window of
the AFC can be increased with a factor 3. The setting is realised with the AFW bit.
Depending on the type the AGC-detector operates on top-sync level (single standard versions) or on top sync and top
white-level (multi standard versions). The demodulation polarity is switched via the I?C-bus. The AGC detector time-constant
capacitor is connected externally. This mainly because of the flexibility of the application. The time-constant of the AGC
system during positive modulation is rather long to avoid visible variations of the signal amplitude.