Схема и документация усилителя Other MORLEY ABY SWITCH

Формат файла: PDF

THANK YOU!
For purchasing a Morley pedal.
Please take a few minutes to familiarize yourself with
the feature of your new pedal. With common sense
handling, it should last for years. We know you will
appreciate the rugged construction of your Morley.
Most of all, we hope you enjoy it as much as we enjoyed
building it.
The ABY switch can take one signal (such as a single
guitar) and split it to your choice of two outputs - A &
B (see Example 1). It can also take two signals (such as two guitars) and route them to one amp allowing you to
switch to either of the two (see Example 2). LED
indicators show which signal is engaged at all times.
NOTE: A cord must be plugged into B in order to
engage the unit.
The ABY box has two switches. The first switch
(labeled "A or B") allows both A and B signals to be
used simultaneously. The second switch chooses
between A or B. LED indicators show the box status.
CONNECTIONS
Example #1 shows a setup in which two output signals
are used (two amps in this case). A would be amp #1, B would be amp #2. The guitar would be plugged into the
"IN/OUT jack.
Example #2 shows two guitars hooked up to one amp.
This would allow for quick changeovers of multiple
EXAMPLE #2
You'll notice that cords fit tightly into the ?" jacks. The
tight fit helps cords from becoming accidentally
unplugged from the pedal. To avoid poor performance,
make sure cords are completely plugged into the input
and output jacks.
The ABY is designed to use one 9 volt battery. We
suggest you use a good quality alkaline battery. The unit
will function without a battery although the LED's will
not function unless a 9 volt battery is installed.