Схема и документация усилителя HL MORLEY SAPHIRE PANGER SFB

Формат файла: PDF

For purchasing a Morley® pedal.
Please take a few minutes to familiarize yourself with thefeatures of your new pedal. With common sense handling,it should last for years. We know you will appreciate therugged construction of your Morley®. Most of all, we hopeyou enjoy using it as much as we enjoyed building it.
The Sapphire Flanger has three controls: SPEED, TRAVEL& REGEN (regeneration). Understanding these controlswill help you to get the sound you are looking for.
The SPEED control determines the speed of the flangeeffect. A slow speed would give you a long swirl typeeffect versus a fast speed which is comparable to a vibratoeffect. You will notice the LED blinks in real time with thespeed that is set. Keep in mind that your overall sound is aproduct of your guitar, amp, pickups, effects, cables,strings and of course - playing style.
The TRAVEL control alters the sweep of harmonicovertone that will be heard when playing. Again, refer tothe sample setting section of this manual for hints.
The REGEN (regeneration) control adjusts the amount offlange signal mixed with dry signal.
CONNECTIONS
IN: Input jack. Plug instrument into this jack using 1/4"guitar cable.OUT: Connect amplifier to this jack using a 1/4" guitarcable.9V: Connect Morley 9 volt regulated AC adapter to thisjack.
NOTE: You'll find your cord fits very tightly into our inputand output jacks. The tight fits helps prevent the cord frombecoming accidentally unplugged from the pedal. Makesure the cords are completely plugged in for best results.
Use only Morley's 9-volt regulated adapters. Using a non-regulated adapter could cause a low frequency hum inyour amplifier.
The SAPPHIRE FLANGER is designed to use one 9 voltbattery when not using an adapter. We suggest you use agood quality alkaline battery.Your pedal is designed for long battery life. To prolongbattery life, unplug your cord completely from the inputjack when not using the pedal. When the pedal is not usedfor extended periods, we recommend you remove thebattery from the pedal or replace it every six month toprevent leakage problems.
BATTERY REPLACEMENT
When the battery becomes weak, the overall flange effectwill be noticeably weak as well.Remove the battery door located on the bottom of thepedal. (a short cord is attached to the door to help preventloss. Once the door is off, the old battery can be removedfrom the battery snap and a new battery plugged in. Makesure the polarity (+/-) is correct before inserting the newbattery.When you replace the battery door , you will notice it fitsvery tightly against the battery. This prevents the batteryfrom rattling inside the pedal.
All Morley® pedals are warranted for two years from dateof purchase. To obtain warranty service call1-800-639-4668.
SPECIFICATIONS
POWER: 9 Volt BatteryCURRENT DRAW: 15 mA @ 9 VDCWEIGHT: 1.2 lb./ .55 kgINDICATOR: Flange effect on or Bypassed
185 Detroit Street, Cary, IL 60013 Phone:(847) 639-4646Fax: (847) 639-4723