Схема и документация усилителя Other MORLEY DIAMOND DISTORTION DDB

Формат файла: PDF

For purchasing a Morley® pedal.
Please take a few minutes to familiarize yourself with thefeatures of your new pedal. With common sense handling,it should last for years. We know you will appreciate therugged construction of your Morley®. Most of all, we hopeyou enjoy using it as much as we enjoyed building it.
The Diamond Distortion has three controls: DRIVE, TONE& LEVEL. Understanding these controls will help you toget the sound you are looking for.
The DRIVE control determines the amount of distortion bydriving up the input signal. See diagrams in the samplesettings section of this manual. Keep in mind that youroverall sound is a product of your guitar, amp, pickups,effects, cables, strings and of course - playing style.
The TONE control allows you to adjust the tone of yoursound from a subtle bass frequency to a biting treblesound. Again, refer to the sample setting section of thismanual for hints.
The LEVEL control adjusts your overall output level whenin distortion mode. Adjust this control to equal the level ofthe distortion to the bypassed signal OR turn it up pasthalfway to get a boost when you engage the distortion.
CONNECTIONS
IN: Input jack. Plug instrument into this jack using 1/4"guitar cable.OUT: Connect amplifier to this jack using a 1/4" guitarcable.9V: Connect Morley 9 volt regulated AC adapter to thisjack.
NOTE: You'll find your cord fits very tightly into our inputand output jacks. The tight fits helps prevent the cord frombecoming accidentally unplugged from the pedal. Makesure the cords are completely plugged in for best results.
Use only Morley's 9-volt regulated adapters. Using a non-regulated adapter could cause a low frequency hum inyour amplifier.
The DIAMOND DISTORTION is designed to use one 9 voltbattery when not using an adapter. We suggest you use agood quality alkaline battery.Your pedal is designed for long battery life. To prolongbattery life, unplug your cord completely from the inputjack when not using the pedal. When the pedal is not usedfor extended periods, we recommend you remove thebattery from the pedal or replace it every six month toprevent leakage problems.
BATTERY REPLACEMENT
When the battery becomes weak, the overall tone of thedistortion will be noticeably weak.Remove the battery door located on the bottom of thepedal. (a short cord is attached to the door to help preventloss. Once the door is off, the old battery can be removedfrom the battery snap and a new battery plugged in. Makesure the polarity (+/-) is correct before inserting the newbattery.When you replace the battery door , you will notice it fitsvery tightly against the battery. This prevents the batteryfrom rattling inside the pedal.
All Morley® pedals are warranted for two years from dateof purchase. To obtain warranty service call1-800-639-4668.
SPECIFICATIONS
POWER: 9 Volt BatteryCURRENT DRAW: 10 mA @ 9 VDCWEIGHT: 1.2 lb./ .55 kgINDICATOR: Distortion on or Bypassed
185 Detroit Street, Cary, IL 60013
Phone: (847) 639-4646
Fax: (847) 639-4723
www.morleypedals.com